CR18P V3/V2 T-hunter "Fused" Skid Plate

CR18P V3 T-Hunter "Fused" skid printed in Carbon fiber nylon pa12cf.

Install is very simple, but the mounting screw locations are changed. One alignment hole is used and one original screw hole is used. 

The skid designed to get you to the next obstacle.

Entire motor/transmission moved forward and tipped for better center of gravity.

Lower link mounting locations improved, fixed any driveshaft rub with high clearance links, and fixes the axle angle needed to achieve full clearance with the driveshafts.

Improves breakover angle.

Provides a smoother profile to eliminate hang ups.

Nearly 3mm of ground clearance gained at the skid 

Approx 0.75mm of skid material protruding from the chassis to help prevent the aluminum chassis from creating friction and sliding.

Compatible with all of the CR18P V3 T-hunter parts from Fused RC.

Note: You must trim the small section of the roll cage that is pictured, directly above the transmission. and also move the upper front links to the position pictured(one forward).